Aeiou Finger Holder
Round Rectangle RcR Smile
라운드 렉탱글 심볼 마크가 들어간 핑거홀더입니다.
하드케이스 사용시 미끄러움 방지 및 스탠드 역할을 합니다.
3단계 높이 조절이 가능하며 에폭시 코팅으로 깔끔하게 마감했습니다.
핑거홀더 유의사항
1.핑거홀더 부착시 부착 표면에 이물질 또는 물기가 없는 상태에서 부착해주세요. 부착 후 5분 정도 꾹꾹 눌러주세요.
2.접착은 높은 습기(장마철, 비오는 날)에 노출되거나 장시간의 통화로 인한 발열로 인해 접착이 떨어질 수 있습니다.
3.외부 열기(예)사우나, 뜨거운 자동차 안)에 의해 접착이 떨어질 수 있습니다.
이는 제품의 불량이 아니라 접착제의 특성입니다.
접착이 떨어졌을 경우 새로운 홀더 접착제를 붙여 사용하시면 재사용이 가능합니다.
서비스로 여분의 3M 접착제를 1개씩 챙겨드리고 있습니다.
Fingerholder Precautions
1. When attaching the finger holder, attach it without any foreign matter or moisture on the surface of the attachment. Press it down for about 5 minutes after attaching it.
2. Adhesion may be exposed to high moisture (rainy season, rainy day) or may be caused by heat generation due to long calls.
3. External heat (e.g. saunas, hot cars) may cause the adhesion to fall.
This is not a defective product, but a property of the adhesive.
If the glue falls off, it can be reused by attaching a new holder adhesive.
We give you extra 3M adhesive for free.
부착방법 How to Attach
1.부착할 위치에 이물질 및 물기를 제거해주세요.
Remove contamination and moisture in the attachment location.
2. 홀더 뒷면의 3M비닐을 제거해주세요.
Remove the 3M vinyl on the back of the holder.
3. 부착할 곳에 살짝 올린 후 눌러주세요.
Place it slightly on the attachment and press it.
4.충분한 시간동안 눌러주세요.
Press hard enough time.
부착이 힘든 경우 Difficult to attach
1. 특수 코팅 처리된 케이스 (실리콘, 파우더리한 실리콘 케이스는 부착 불가능)
Special coated case (silicon or powdery silicon case cannot be attached)
2. 곡면부위
Curved area
3. 가죽소재
Leather Material
4. 음/양각 패턴(단차가 있는 케이스)
Negative/Revolving Patterns (Cases with Steps)